Top splash resistance tester factory? Universal testing machine (also known as tensile testing machine) that performs tensile, compression, flexure, peel, tear, shear, friction, and other types of mechanical testing in accordance with ASTM, ISO, and other industry standards. GESTER Abrasion Tester Professional manufacturer, providing a full range of solutions, Martindale Abrasion Tester in line with ASTM, ISO and other standard requirements, factory direct sales. Discover more information on synthetic blood penetration test equipment.
Application of Universal Testing Machine: This types of tensile testing machines is designed for conducting tensile, compression, bending, shearing, bonding strength, peeling, tearing and other tests for shoes, rubber, plastic, leather, metal, nylon line, fabric, paper, aviation, packaging, construction, petrifaction, electrician, vehicle and other materials. It is a basic equipment of quality control, receiving inspection, physical test, mechanics research, material development.
Correct use of computerized universal testing machine: Make sure all wiring is correct before the tensile testing machine is operated and preheat for at least 15 minutes to package the stability of the sensor. According to the test, the position of the upper and lower limit blocks is reasonably set to prevent the instrument from running over the stroke and causing damage to the fixture and the sample. When pressing the fast up button or the fast down button, do not put your hand between the moving beam and the fixed specimen, fixture or test device to avoid injury.
ASTM D4060 Taber Abrasion Testing: Taber rotary type abrasion tester is a specification that determines the “Abrasion Resistance of Organic Coatings by the Taber Abraser.” Although written for organic coatings, the same method applies to inorganic coatings. At the conclusion of testing the sample(s) are then re-weighed. The wear index is then calculated by taking the average mass loss per 1,000 cycles per section 12 of ASTM D4060. Assured Testing Services has multiple taber abrasion machines that meet the ASTM D4060 standard. One of our machines is shown with an exposed sample on this page.
Reagent Preparation: Prepare corresponding reagents according to different test standards and keep them as standby. If sodium perborate is required in the test, the preheating temperature shall not exceed 60℃ when preparing the solution, and it shall be used within 30 minutes at most to prevent the loss of oxidant. Solution Warm-up: Put the specified volume of solution and a specified number of steel balls into the stainless steel cup, put the stainless steel cup into the launderometer for a few minutes, preheat to the specified temperature. Then put in the prepared sample for test. See additional info on https://www.gesterinstruments.com/.